VIGO PHOTONICS · SMART TAIWAN
AM03100-02 infrared detection module
AM03100-02
An uncooled InAsSb infrared detection module with an integrated differential amplifier on an approximately 10 × 10 mm solderable PCB. Intended for single-point sensing designs with separately engineered optics and readout.
Specifications and configuration
| Material / detection | InAsSb / photovoltaic |
|---|---|
| Active / optical area | 1 × 1 mm (active area) |
| Typical spectral range | 1.7–5.9 μm (Tamb 20°C) |
| Peak wavelength | 4.0 μm (typ.) |
| Typical responsivity | 360 V/W (λpeak) |
| Typical D* | 5.0 × 10⁸ cm·Hz½/W (λpeak, 1 kHz) |
| Typical bandwidth | DC–3.0 MHz |
| Supply | 3.0 V (specified operating point) |
| Signal output | Differential analogue output |
| Cooling / temperature control | Uncooled; no integrated TEC controller |
| Outline / interface | 10 × 10 mm PCB; 12 solderable pads |
Tamb = 20°C; +3.0 V; Rload = 1 MΩ to ground unless noted.
Typical values are not guaranteed limits. Refer to the original English datasheet for full test conditions, minimum / maximum values and operating limits. D* figures measured at different frequencies are not directly comparable.
Manufacturer spectral response
Selection and integration considerations
- There is no integrated TEC control; assess how ambient temperature affects response, baseline and calibration.
- This is a solderable PCB module. Follow the manufacturer drawing for soldering, mounting and optical alignment; it is not an enclosed instrument.
- Provide a differential receiver and acquisition circuitry; confirm supply, loading and optical power against the datasheet.
From module to measurement system
- Source / measurement target
- Filters and optical coupling
- IR detection module
- Differential receiver / ADC
- Signal processing and calibration
The module provides part of the sensing and analogue chain. A complete measurement also needs optics, power, readout and calibration.
Original English documents and resources
V2.0 · 2025-02-05
Start with your measurement requirements
Share the model or application, wavelength, signal bandwidth, quantity and desired schedule. Unknown items can be discussed during selection.
Submit a VIGO inquiry